Worcester Bosch showing A1 in Sutton Coldfield? It usually points at low water flow or the pump. What you can check safely and what an engineer looks for.
Gas Safe registered engineers
Fully insured, work guaranteed
Fixed prices, no call-out fee
Local to Sutton Coldfield
On many Worcester Bosch boilers, A1 means the boiler cannot detect enough water moving through it. Some models show a number such as 280 alongside. The pump may be struggling, or there may simply not be enough water in the system. Your manual has the exact meaning for your model.
The boiler stops to protect itself. Running a burner with no water moving past it would damage the heat exchanger, so the code is doing its job.
In Boldmere and Wylde Green the combi is often in a kitchen cupboard with a long run of pipe to the bedrooms. After any plumbing work, air can sit in that run and upset the flow. In the bigger Four Oaks homes the pump may be working against a long, complicated system with zone valves.
The boiler has stopped because the water was not moving. It is protecting itself. If you smell gas, leave the house, do not touch switches and ring the National Gas Emergency line on 0800 111 999 from outside.
That points at air in the system. Bleeding and topping up often clears it. If it does not, the pump may need a hand to clear the airlock.
Sometimes a stuck pump can be freed. More often the pump head is replaced. It is a common job and usually done in one visit.
Most A1 faults are sorted on the first visit. If a part has to be ordered, it is usually a day or two.
If the pressure is low, top it up using the filling loop as your manual describes. Low pressure is one of the most common reasons for A1, and the easiest to fix.
If upstairs radiators are cold at the top, bleed them with a radiator key. Then check the gauge again, because bleeding lets pressure out and you may need to top up.
A pump that hums, rattles or makes no sound at all is worth mentioning when you get in touch. It helps us bring the right part.
Reset once after topping up. If A1 comes back, stop there. A pump running dry again and again can wear itself out.
The pump, the pressure sensor, any airlocks, and the flow through the boiler. On system boilers in Four Oaks we also check the zone valves, because a stuck valve can look like a pump fault.
A photo of the code and the gauge, the boiler model from the label, and whether any plumbing work was done recently. That last detail often explains an airlock straight away.
A new boiler supplied and fitted by Gas Safe registered engineers - honest advice on the r…
Learn more →An annual service keeps your boiler safe, efficient and - importantly - keeps the warranty…
Learn more →Fast CP12 landlord gas safety certificates for rented homes across Sutton Coldfield - …
Learn more →Cold radiators, a noisy system or rooms that never warm up? We repair, upgrade and power f…
Learn more →Homeowner or landlord, we've got Sutton Coldfield covered: repairs, servicing, installs and certificates. Leave your details and a local engineer will get back to you fast.
Send a photo of the problem on WhatsApp for the quickest reply, or give us a call. You get a free, no-obligation quote, usually the same day.